|
CALLIES and
COMPSTAR Rotating Assemblies:
 1-piece
rear main Compstar forged
383 Rotating Assembly:
$1980.00
A superior quality all forged 383 rotating assembly consisting of
the 4340 forged Compstar 1-piece rear
crankshaft, 6.0" Compstar H-beam rods, U.S.A. made Mahle pistons
with rings, pins and locks,
(your choice of flat top or dished piston), and ACL main and rod
bearings. Callies does all the engineering on this rotating
assembly and the kit arrives fully balanced, (internal/neutral).
Callies Dragonslayer
383 Rotating Assembly upgrade:
$2345.00
Substitute the USA made Callies Dragonslayer in place of the
Compstar crank. Of course the kit retains the 6.0" Compstar H-beam rods, Mahle pistons
with rings, pins and locks,
(your choice of flat top or dished piston), and ACL main and rod
bearings. Callies does all the engineering on this rotating
assembly and the kit arrives fully balanced, (internal/neutral).
 Please see the
Callies web site for
a good rundown on the heat treat and stress relief and attention to
detail that goes into manufacturing Callies and Compstar
components. To purchase any Callies or Compstar components
from Ellwein Engines please call Karl Ellwein at 410-474-5579 or email karl.ellwein@radix.net
Mahle OEM quality main bearings for SBC and LT1 clearance price $20/set
Mahle OEM quality rod bearings for SBC and LT1 clearance price $20/set
Mahle OEM quality LT1 piston ring set clearance price $105/set
Hastings OEM quality LT1 piston ring set clearance price $105/set
©Ellwein
Engines 2007
|
